User's Manual

General Information
98
QUICK START Position
The QUICK START position operates the
electric starter allowing for a quicker
ignition start.
From the ignition off, press and hold the
engine start/stop switch in the
QUICKSTART position with all the correct
conditions met, to start the motorcycle.
For more information, see
page 148
.
RUN Position
The engine start/stop switch must be in
the RUN position for the motorcycle to
operate.
STOP Position
The STOP position stops the engine.
Note:
• Although the engine stop position
stops the engine, it does not turn
off all the electrical circuits and
may cause difficulty in restarting
the engine due to a discharged
battery. Ordinarily, only the ignition
switch should be used to stop the
engine.
Power ON/OFF Position
The Power ON/OFF position switches
the electrical circuits and the
instrument display between on or off.
This allows access to the instrument
display without starting the engine
when switched ON.
Caution
Do not leave the switch in the Power
ON position for a long period of time as
this may cause damage to electrical
components and will discharge the
battery.
Hazard Warning Lights Button
To turn the hazard warning lights on or
off, press and release the hazard
warning light button.
The ignition must be switched on for
the hazard warnings lights to be
activated, but the hazard lights will
remain active if the ignition is switched
off until the hazard warning light button
is pressed again.
Steering Lock Button
To lock the motorcycle, turn the
handlebar fully to the left and press the
steering lock button.
When the ignition is off then the engine
immobiliser is on. The engine immobiliser
is turned off when the ignition is
started.
Warning
For reasons of security and safety,
always make sure the steering lock is
on when leaving the motorcycle
unattended.
Any unauthorised use of the
motorcycle may cause injury to the
rider, other road users and pedestrians
and may also cause damage to the
motorcycle.