User's Manual

Instruments
63
If the indicator light remains on it
indicates that the immobiliser has a
malfunction that requires investigation.
Contact an authorised Triumph dealer
as soon as possible to have the fault
checked and rectified.
With Alarm Fitted
The immobiliser/alarm light will only
illuminate when the conditions
described in the genuine Triumph
accessory alarm instructions are met.
ABS (Anti-Lock Brake System)
Warning Light
When the ignition switch is
turned to the ON position, it is normal
that the ABS warning light will flash on
and off. The light will continue to flash
after engine start-up until the
motorcycle first reaches a speed
exceeding 6 mph (10 km/h) when it will
go off.
The warning light should not illuminate
again until the engine is restarted
unless there is a fault, or:
• ABS is disabled by the rider - the
warning light will remain illuminated
(see Bike Setup on
page 79
or
Riding Mode Configuration on
page
87
).
• ABS is set to Off-Road – the
warning light will flash slowly (see
Riding Mode Configuration on
page
87
).
Note:
• Traction control and cruise control
may not function if there is a
malfunction with the ABS system.
In this situation, the warning lights
for the ABS, traction control and
the MIL may be illuminated.
If the warning light becomes illuminated
at any other time while riding it
indicates that the ABS has a
malfunction that requires investigation.
The following warning message may be
displayed:
• WARNING - ABS SYSTEM DISABLED
The braking system will be affected as
follows:
WARNING - ABS SYSTEM DISABLED
OFF-ROAD
WARNING
ABS SYSTEM
DISABLED
CHECK MANUAL
PRESS SELECT
TO CLEAR
1
2
1. ABS warning light
2. Instrument message
The message WARNING - ABS SYSTEM
DISABLED indicates that the ABS is not
functioning.