User's Manual

General Information
114
Tyre Pressure Monitoring
System (TPMS) (if fitted)
Warning
The daily check of tyre pressures must
not be excluded because of the fitment
of the TPMS. Check the tyre pressure
when the tyres are cold and using an
accurate tyre pressure gauge (see
page 196
).
Use of the TPMS system to set
inflation pressures may lead to
incorrect tyre pressures leading to loss
of motorcycle control and an accident.
Function
Tyre pressure sensors are fitted to the
front and rear wheels. These sensors
measure the air pressure inside the tyre
and transmit pressure data to the
instruments. The sensors will not
transmit data until the motorcycle
reaches a speed of approximately
12 mph (20 km/h). Two dashes will be
visible in the system display until the
tyre pressure signal is received.
After bring the motorcycle to a stop, the
sensors continue to transmit data for
approximately seven minutes before
switching off. The tyre pressure values
remain visible in the system display until
the sensors switch off.
An adhesive label will be fitted to the
wheel rim to indicate the position of the
tyre pressure sensor, which is near the
valve.
Note:
• The Tyre Pressure Monitoring
System (TPMS) is available as an
accessory kit. It must be fitted by
your authorised Triumph dealer.
• The TPMS display on the
instruments will only be activated
when the system has been fitted.
Tyre Pressure Sensor Serial Number
The serial number for the tyre pressure
sensor is printed on a label attached to
the sensor. This number may be
required by your authorised Triumph
dealer for service or diagnostics.
When the tyre pressure monitoring
system is being fitted to the motorcycle,
make sure that your authorised Triumph
dealer records the serial numbers of the
front and rear tyre pressure sensors in
the spaces provided below.
Front Tyre Pressure Sensor
Rear Tyre Pressure Sensor