User's Manual

General Information
104
Pass Function
With the headlight dip switch set to the
dip beam position, pressing the bottom
of the switch will activate the pass
function.
When pressed, the headlight high beam
will be switched on. It will remain on as
long as the switch is held in and will
turn off as soon as the switch is
released.
Note:
• A lighting on/off switch is not fitted
to this model. The position light,
rear light and licence plate light all
function automatically when the
ignition is turned to the ON
position.
• The headlight will function when
the ignition switch is turned to the
ON position and the engine is
running.
There are two alternate ways to turn on
the headlight without the engine
running:
• Pull in the clutch lever then turn
the ignition to the ON position. The
headlight will be on and will remain
on when the clutch lever is
released.
• With the ignition on and the
headlight dip switch set to the dip
beam position, pressing the bottom
of the switch will activate the
headlight. The headlight will remain
on when the switch is released.
The headlight will go off while pressing
the starter button until the engine
starts.
Direction Indicator Switch
When the indicator switch is pushed to
the left or right and released, the
corresponding direction indicators will
flash on and off. To turn off the
indicators, push and release the switch
in the central position.
Horn Button
When the horn button is pushed, with
the ignition switch turned to the ON
position, the horn will sound.
Instrument SELECT Button
When the SELECT button is pressed and
released it will select the menu
highlighted in the multifunction display
screen.
Pressing and holding the SELECT button
when the motorcycle is stationary will
activate the Settings Menu in the
multifunction display (see Settings Menu
on
page 77
).