User's Manual

General Information
120
To adjust the handlebars:
• Loosen and remove the handlebar
rear (0.31 in (8 mm) threaded) clamp
bolts, and then the front (0.39 in
(10 mm) threaded) clamp and riser
bolts.
2
1
chiv_3
1. 0.39 in (10 mm) bolts
2. 0.31 in (8 mm) bolts
• Lift the handlebars out of the
handlebar risers and support with
the aid of an assistant.
• Rotate both risers through 180°
and align the bolt holes.
• Reposition the handlebars to the
risers.
2
3
1
chiu_2
1. Upper clamp, left hand
2. Clamp split line, front
3. Handlebar alignment mark
• Reinstall the upper clamps, and
secure with the two 0.39 in (10 mm)
threaded bolts in the rear bolt
positions. Do not fully tighten the
bolts at this stage.
• Rotate the handlebar so that the
alignment marking on the
handlebar aligns with the front left
hand split line of the clamp riser.
• Tighten the 0.39 in (10 mm) bolts to
26 lbf ft (35 Nm).
• Reinstall the 0.31 in (8 mm) bolts to
the front positions and tighten to
19 lbf ft (26 Nm).