User's Manual

89
GARAGE DOOR OPENER
PROGRAMMING ROLLING CODE
DEVICE EQUIPMENT
Note: The assistance of a second person
may make the following steps quicker and
easier. Once the button has been pressed
there are only 30 seconds in which to
complete Step 3.
1. At the garage door opener receiver
(motor head unit) in the garage, locate
the learn or smart button/switch.
The name of the button or switch may
vary between manufacturers.
2. Press and release the learn or smart
button.
3. Return to the vehicle and firmly press
and hold the programmed garage door
opener button for two seconds and
release.
4. Repeat the press, hold, release
sequence three times to complete the
programming process.
5. The garage door opener in the rear-
view mirror should now activate the
rolling code device.
REPROGRAMMING A SINGLE BUTTON
To program a device to a previously trained
button:
1. Press and hold the desired pre-
programmed garage door opener
button for at least 20 seconds, but no
longer than 30 seconds, until the
indicator light begins to flash.
2. Without releasing the rear-view mirror
button, position the hand-held
transmitter approximately 1-3 inches
(25 - 75 mm) away from the transceiver
in the rear-view mirror, keeping the
indicator light in view.
3. Carry out Step 3 of Programming a
Device. See “Programming a Device” on
page 88.
ENTRY GATE/CANADIAN
PROGRAMMING
The technology of some entry gates
requires you to press and re-press (cycle)
the hand-held transmitter button every
two seconds during programming.
Continue to press and hold the desired
rear-view mirror button while you cycle
your hand-held transmitter until the
indicator light flashes rapidly.
INFORMATION AND
ASSISTANCE
CAUTION: For security purposes, it is
recommended that all programmed
transceiver buttons are erased before the
vehicle is sold or disposed of.
For information on the range of available
compatible products or accessories, or for
assistance, you should contact your Dealer.
If you would like additional information on
the Homelink Universal Transceiver,
compatible products or to purchase other
accessories, contact your Dealer or you can
also contact the Homelink helpline at
1-800-355-3515 or www.homelink.com.
Note: Keep the original transmitter for
future use or programming procedures if,
for example, you purchase a new vehicle.
Note: The manufacturer is not responsible
for any radio or TV interference caused by
unauthorized modifications to this
equipment. Such modifications could void
the user’s authority to operate the
equipment