User's Manual

29
SEATS AND STEERING COLUMN
The Driver’s last used saved seat position
will be automatically recalled if the
following occurs:
• The car is in Park [P].
• A programmed key fob is present.
• The driver’s door goes from “open” to
“closed” (or the door is “open” and the
driver places vehicle in vehicle in
System Ready mode as if going to drive
the car).
• The Driver seat is not in the last saved
seat position location.
MEMORY SETTING PROCEDURE
1. Select [SETTINGS].
2. Select [INTERIOR].
3. Select the Memory/Seat Position
selection.
4. Adjust the driver seat and steering
wheel for Driver #1.
5. Touch the “Set” selection (under the
Primary Seat Memory selection).
Repeat the above steps for the Secondary
Seat Memory.
EASY ENTRY AND EXIT
Entry and exit mode provides automatic
movement of the steering column and
driver’s seat making it easier to enter or exit
the vehicle. Easy entry/exit is enabled and
settings can be programmed in the CIU
under the interior section located under
vehicle settings.
Note: This feature can be enabled or
disabled via the vehicle’s touchscreen.
ENTRY
When a programmed key fob is detected
outside the vehicle and the driver door
goes from “closed” to “open.” The steering
column and driver’s seat will return to the
previous position.
EXIT
When the vehicle is powered-down, the
steering column will move to the
uppermost tilt position and the driver’s
seat will move to the exit position.
Note: If the steering column or driver’s seat
is adjusted during entry or exit operation,
automatic movement will stop.