User's Manual

17
LOCKING AND UNLOCKING THE VEHICLE
2. Key Fob Unlocking:
• Press unlock button once to unlock
the driver door. Press a second time
to unlock all doors.
• The horn should sound once and the
park lights should flash once.
Passive Unlock:
• When a programmed key fob is in
your possession, activate an exterior
door handle. The driver door should
unlock.
• The horn should sound once and the
park lights should flash once.
• This feature can be programmed to
unlock all doors through the CIU.
3. Trunk
• Press and hold the trunk release
button for 3 seconds to unlock the
trunk.
Note: The lock and unlock settings for your
Revero can be configured to your personal
preferences via the touchscreen.
The buttons on the key fob transmit a
coded radio signal to a receiver in your
Revero. It is not necessary to point the key
fob at your vehicle, but you must be within
operating range. The operating range will
vary according to the condition of the key
fob battery and other physical factors.
If the vehicle cannot be locked or unlocked
using the buttons on the key fob, you may
need to change the key fob battery.
Note: Interference from other radio
equipment operating on a similar
frequency may also affect the operation of
the key fob. If this happens, operate the key
fob as close to your vehicle as possible. If
you are still unable to unlock your vehicle
with the key fob, use the manual door lock.
MEDICAL SAFETY
WARNING: Any person with an
implanted medical device should
ensure that the device is kept at a distance
of at least 8.7 inches (22 cm) away from
any transmitter mounted in the vehicle.
This is to avoid any possibility of
interference between the system and the
device. Interference may cause the
implanted medical device to malfunction,
causing serious injury or death.
Transmitters which detect the presence of
the key fob are located in the following
locations on your Revero:
1. Behind the touchscreen.
2. Beneath the center console.
3. Trunk - underside of the rear parcel
shelf.