User's Manual

General Information
94
Passenger Seat
1. Seat lock
The seat lock is located on the rear
mudguard, below the rear light unit. To
remove the seat, insert the ignition key
into the seat lock and turn it
anti-clockwise while pressing down on
the rear of the seat. This will release the
seat from its lock and allow it to be slid
rearwards. If equipped with heated
seats, disconnect the heated seat’s
electrical connector for complete
removal from the motorcycle.
To refit the seat, reconnect the heated
seat’s electrical connector (if equipped),
engage the seat's two outer brackets
under the loops on the subframe and
the two inner brackets to brackets on
the rider's seat. Gently push the seat
forwards and press down at the rear to
engage in the seat lock.
1. Passenger seat outer brackets
2. Subframe loops
3. Passenger seat inner brackets
4. Rider seat brackets
1
Warning
To prevent detachment of the seat
during riding, after fitting always
grasp the seat and pull firmly
upwards. If the seat is not correctly
secured, it will detach from the lock. A
loose or detached seat could cause
loss of motorcycle control and an
accident.
1
2
3
1
4