User's Manual

General Information
91
Handlebar Adjustment
The handlebars are adjustable for reach
by approximately 20 mm.
Note:
• This procedure assumes the
handlebars are in the standard
position, as delivered from the
factory. If the handlebars have
already been adjusted as described
below, the bolt positions will be
reversed.
To adjust the handlebars, loosen and
remove the handlebar rear (8 mm
threaded) clamp bolts, and then the
front (10 mm threaded) clamp and riser
bolts.
1. 10 mm bolts
2. 8 mm bolts
Lift the handlebars out of the handlebar
risers and support with the aid of an
assistant.
Rotate both risers through 180° and
align the bolt holes.
Reposition the handlebars to the risers.
Refit the upper clamps, and secure with
the two 10 mm threaded bolts in the rear
bolt positions. Do not fully tighten the
bolts at this stage.
Warning
It is recommended to have handlebar
adjustments carried out by a trained
technician of an authorised Triumph
dealer. Handlebar adjustments carried
out by a technician who is not of an
authorised Triumph dealer may affect
the handling, stability or other aspects
of the motorcycle’s operation which
may result in loss of motorcycle
control and an accident.
Warning
Before starting work, ensure the
motorcycle is stabilised and
adequately supported. This will help
prevent injury to the operator or
damage to the motorcycle.
2
1
chiv_3