User's Manual
General Information
78
Note:
• To activate cruise control, the
following conditions have to be met:
• The motorcycle must be travelling at
a speed between 19 to 100 mph
(30 to 160 km/h).
• The motorcycle must be in 3
rd
gear
or higher.
Once these conditions have been met,
press the SET/- button to activate
cruise control.
The word SET will be visible below the
cruise control symbol, the cruise control
set speed will be displayed and the
cruise control light will illuminate in the
tachometer indicating that cruise
control is active.
1. Cruise control symbol
2. Cruise control set indicator
3. Cruise control set speed
4. Cruise control light
The cruise control system will maintain
the set speed until:
• The set speed is adjusted as
described on page
78
• Cruise control is deactivated as
described on page
79.
Adjusting the Set Speed While in
Cruise Control
To adjust the set speed while in cruise
control, press and release the:
• RES/+ button to increase the speed
• SET/- button to decrease the speed.
Each press of the buttons will adjust the
speed by 1 mph or 1 km/h. If the buttons
are held, the speed continuously
increases or decreases in single digit
increments.
Stop pressing the adjust button when
the desired speed is shown in the
display.
Note:
• The cruise control set speed display
will flash until the new set speed has
been achieved.
• If riding up a steep incline and cruise
control is unable to maintain the set
speed, the cruise control set speed
display will flash until the motorcycle
has regained the set speed.
1. Cruise control set speed (flashing)
2. Current road speed
An alternative way to increase the
speed in cruise control is to accelerate
to the desired speed using the throttle
grip and then press the SET/- button.
4
1
2
3
1
2