User's Manual

General Information
61
Incomplete Riding Mode Changes
In the event of an incomplete riding
mode change, both the previous and
newly selected riding modes will be
highlighted with a dashed border. This
indicates that the ABS, MAP, TC or TSAS
settings specified by the newly
requested riding mode have not been
correctly activated.
1. Incomplete riding mode change
In this case the MIL, ABS, TC or TSAS
warning light(s) may be illuminated
depending on the current state of each
system.
In the event of an incomplete riding
mode change:
• Safely bring the motorcycle to a stop
• Select neutral gear
• Turn the ignition OFF and then back
ON again
• Select the desired riding mode
• Restart the engine and continue
riding.
OFF-ROAD
OFF-ROAD
OFF-ROAD
OFF-ROAD
OFF-ROAD
C N S
MAP
1
Warning
Do not stop the engine using the
ignition switch or engine stop switch
whilst the motorcycle is moving.
Always bring the motorcycle to a stop
safely and engage neutral gear prior
to stopping the engine.
Stopping the engine by turning off the
ignition or engine stop switch whilst
the motorcycle is moving can lock the
rear wheel causing loss of motorcycle
control and an accident.
Caution
Do not stop the engine using the
ignition switch or engine stop switch
whilst the motorcycle is moving.
Always bring the motorcycle to a stop
safely and engage neutral gear prior
to stopping the engine.
The transmission is pressure-
lubricated only when the engine is
running. Inadequate lubrication may
cause damage or seizure of the
transmission, which can lead to
sudden loss of motorcycle control and
an accident.