User's Manual

General Information
52
After entering the ABS screen press the
SCROLL button to select ENABLE or
DISABLE.
ABS (ENABLE Shown)
Press the SELECT button to confirm
your selection and return to the BIKE
SETUP menu.
If DISABLE is selected, the ABS warning
light will be illuminated and the message
WARNING - ABS SYSTEM DISABLED will
be briefly displayed in the multifunction
display screen.
ABS, optimised cornering ABS (if
equipped) and all riding mode ABS
settings will be disabled until the ABS is
re-enabled.
Note:
If the ABS is disabled by the rider,
traction control, cruise control (if
equipped) and hill hold (if equipped)
will still function.
ABS, optimised cornering ABS (if
equipped) and the riding mode ABS
settings will be automatically enabled
when the ignition is turned off and then
on again.
TC Disable/Enable
It is possible to temporarily disable the
TC system. The TC system cannot be
permanently disabled, it will be
automatically enabled when the ignition
is turned off and then on again.
ABS
ENABLE
Warning
Selecting TC DISABLE will disable the
traction control system.
Optimised cornering traction control (if
equipped) will also be disabled and the
TC settings stored for each riding
mode will be overridden regardless of
whether they are set to Rain, Road,
Sport, Off-Road or Off.
TC, optimised cornering TC and the
riding mode TC settings will not be
enabled again until ENABLE is selected
from the TC menu as described in the
following procedure, or the ignition is
turned off then on again.
If traction control is disabled, the
motorcycle will handle as normal but
without traction control. In this
situation accelerating too hard on
wet/slippery road surfaces may cause
the rear wheel to slip, and may result
in loss of motorcycle control and an
accident.