User's Manual

MAINTAINING YOUR McLAREN
❋
USES
❫ ♦ ♥ ❧
✎
% ❘
✡ ✍ ✡ ✟ ✔ ✡ ✌ ✑ ✡ ✌
❋
✒ ✍ ✒
❋
✡ ✠ ✝ ✍ ✥
❑
✔ ✔ ✡ ✝ ✓ ✠ ✥ ☛
✳
✌ ✑ ✡
panel to the bulkhead and remove the
panel
3. Refer to the fuse specification chart on
page 5.18 to determine which fuse
protects the non-functioning electrical
system.
NOTE: A label identifying the fuses is
attached to the inside of the access
panel.
4. Remove the appropriate fuse and
replace it with a fuse of the same value
as the original. If in doubt, check the fuse
specification chart.
5. Fit the access panel by inserting the two
upper retaining clips in the bulkhead and
securing with the two lower clips.
NOTE: If a replacement fuse does not
solve the electrical problem, or it fails
immediately, contact your McLaren
Retailer.
❂ ❈
✱ ✸ ✫ ✯ ✽ ✪ ❤ ✬
●
✫ ✯ ✽ ✪ ✽
➭
✪
❀
✱ ✫ ✱
❀ ❈
✻ ✱ ✬ ✸
❀
❅
❈
✭ ✻
❝
✬ ♦
❛ ✿ ➭
✽ ✺ ✱ ✭
❀
✯ ✱ ✻
➭
✭ ✬ ✻ ✪
❀
✻ ✪ ✰
F1 60 Secondary Air Pump
F2 - -
F3 - -
F4 - -
F5 30 Powertrain Chassis Control
Unit
F6 30 Powertrain Chassis Control
Unit
F7 30 Starter
F8 20 Heated Mirrors
F9 30 Audio Amplifier (Tier 3)
➋
✗ ✙
➩ ➩
F11 - -
F12 - -
F13 5 Powertrain Chassis Control
Unit
F14 5 Engine Control Module
F15 10 Relays
F16 10 OBD Diagnostics
F17 3 Door Locking Switch
F18 50 ECU Main Relay Control
F19 - -
F20 30 Seat Driver!s
F21 30 Seat Passenger!s
F22 30 Fuel Pump 1
F23 5 Tilt and Microwave Sensor
F24 15 Audio Amplifier (Tier 1 & 2)
F25 10 Driver!s/Passenger!s Door
Latch
No. Amps Circuit protected