Off Grid Installation Manual

INSTALLATION MANUAL GUIDE | DATE: 02/2017
2
I) WARNING
Please read this manual completely before installing solar module. This module produces
electricity when exposed to light. Follow all applicable electrical safety precautions. Only
qualified personnel should install or perform maintenance work on this module. Do not
handle modules when they are wet.
II) INTRODUCTIONS
Solar modules come in various sizes to satisfy a full range of applications. Each module
is made of crystalline-silicon cells. To protect the cells from the most severe-
environmental conditions, modules are made of high transmission rate and low iron
tempered glass, anti-aging encapsulation material, and high climate resistant and
insulation back sheet by hot lamination, with anodized aluminum alloy frame and junction
box.
III) APPLICATIONS
Modules are reliable, virtually maintenance free power supply, designed to operate
efficiently in sunlight. By modules, the solar radiant energy is transformed into electrical
energy for using. Modules, usually be used as one fittings of PV solar system. A set of
basic PV solar system is consisted of PV solar module, controller, inverter, and storage
battery.
Modules can be used in roof PV solar systems, PV stations, building, and other electric
generation application etc widely.
Application Class is Class A.
Modules rated for use in this application class may be used in systems operating at
greater than 50VDC or 240W, where general contact access is anticipated. Modules
qualified for safety through this part of IEC61730 and IEC61730-2 and within this
application class are considered to meet the requirements for safety class II.
IV) CODES and REGULATIONS
The mechanical and electrical installation of PV systems should be performed in
accordance with all applicable coded; including electrical codes, building coded, and
electric utility interconnect requirements. Requirements may also vary with system
voltage, and for DC or AC application.