Off Grid Installation Manual

INSTALLATION MANUAL GUIDE | DATE: 02/2017
11
live parts of cables and connectors. As an added precaution, use insulated tools and
rubber gloves when working with modules in sunlight.
Fall of modules from high place will cause death, injury or damage. Do not drop module
or allow objects to fall on module, never leave a module unsupported or unsecured. If a
module should fail, the glass can break a module with broken glass cannot be repaired
and must not be used.
When installing or working with module or wiring, cover module face completely with
opaque material to halt production of electricity. Modules have no on/off switch. Modules
when exposed to sunlight generate high voltage and are dangerous, modules can be
rendered inoperative only by removing them from sunlight, or by fully covering the front
surface with opaque cloth, cardboard, or other completely opaque material, or by working
with modules face down on a smooth, flat surface when installing or maintaining.
Do not artificially concentrate sunlight on the module.
Modules can produce higher output than the rated specifications. Industry standard
ratings are made at conditions of 1000W/m
2
and 25°C cell temperature. Reflection from
snow or water can increase sunlight and therefore boost current and power. In addition,
colder temperatures can substantially increase voltage and power.
Modules are intended for use in terrestrial applications only, thus excluding aerospace or
maritime conditions or use with sunlight concentration.
It is recommended that the module remains packed in the box until time of installation.
Work only under dry conditions, with a dry module and tools, since sparks may be
produced, do not install module where flammable gases or vapors are present.
Do not drill holes into module frame as it will void warranty. Modules are constructed
frame as it will void warranty.
Handled with care, if the front glass is broken or if the polymer backskin is tom, contact
with any module surface or the frame can produce electrical shock. Particularly when the
module is wet, broken or damaged modules must be disposed of properly. Do not
disassemble, bend, impact by sharp objects, walk on, and throw or drop etc. keep back
surface free from foreign objects.
Avoid sharp edges.
Use module for its intended function only follows all module manufacturers’ instructions.
Do not disassemble the module, or remove any part or label installed by the
manufacturer. Do not treat the back of the module with paint or adhesives.
If not otherwise specified, it is recommended that requirements of the latest local,
national or regional electrical codes be followed.
Retain this installation manual for future reference.
IX) NOTES
The electrical characteristics are within ±5 percent of the indicated values of Isc, Voc, and
Pmax under standard test conditions (irradiance of 100mW/cm
2
, AM 1.5 spectrum, and a
cell temperature of 25°C (77°F).