User's Manual

________________________________________________________________________________________________________________________________________ Site 41
peiker acustic GmbH & Co. KG, Max-Planck-Straße 28-32, D-61381 Friedrichsdorf, Amtsgericht Bad Homburg HRA 1897
phG: peiker Verwaltungs GmbH, Vorsitzender der Geschäftsführung: Andreas Peiker, Geschäftsführer: Reinhard Kromer-von Baerle, Amtsgericht Bad Homburg HRB 1369
Vorsitzender des Aufsichtsrates: Dr. Helmut Rothenberger Ein Unternehmen der peiker Firmengruppe
(c) The provisions of paragraphs (a) and (b) of this section do not apply to digital devices exempted
from the technical standards under the provisions of § 15.103.
(d) For systems incorporating several digital devices, the statement shown in paragraph (a) or (b) of this
section needs to be contained only in the instruction manual for the main control unit.
(e) In cases where the manual is provided only in a form other than paper, such as on a computer disk
or over the Internet, the information required by this section may be included in the manual in that
alternative form, provided the user can reasonably be expected to have the capability to access
information in that form.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
OEM responsibility to the FCC rules and regulations
The US variant without GNSS of the NAD 6200 module is labeled with its own FCC ID Number and IC ID
Number. If the FCC ID is not visible when the NAD6200 module is installed inside another device, then
the host device must contain the FCC ID number with the statement such as the following: “Contains
Transmitter Module FCC ID: QWY-PNADA or Contains FCC ID: QWY-PNADA”.
The US variant with GNSS of the NAD 6200 module is labeled with its own FCC ID Number and IC ID
Number. If the FCC ID is not visible when the NAD6200 module is installed inside another device, then
the host device must contain the FCC ID number with the statement such as the following: “Contains
Transmitter Module FCC ID: QWY-PNADB or Contains FCC ID: QWY-PNADB”.
Modifications
The FCC requires the user to be notified that any changes or modifications made to this device that are
not expressly approved by peiker acustic GmbH & Co. KG could void the user's authority to operate the
equipment.
RF Exposure Warning:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minium distance 20 cm between the radiator and
your body. This transmitter must not be co-located or Operating in conjunction with any other antenna
or transmitter.
Notice:
The preceding statement must be included as a Caution statement in OEM product manuals in order to
alert users of FCC RF Exposure compliance.