User's Manual

________________________________________________________________________________________________________________________________________ Site 37
peiker acustic GmbH & Co. KG, Max-Planck-Straße 28-32, D-61381 Friedrichsdorf, Amtsgericht Bad Homburg HRA 1897
phG: peiker Verwaltungs GmbH, Vorsitzender der Geschäftsführung: Andreas Peiker, Geschäftsführer: Reinhard Kromer-von Baerle, Amtsgericht Bad Homburg HRB 1369
Vorsitzender des Aufsichtsrates: Dr. Helmut Rothenberger Ein Unternehmen der peiker Firmengruppe
9. Evaluation Kit
For the NAD6200 – module there is an evaluation board available.
They have the following features:
- On beard 12 V DC power Supply or 3.8 V DC direct connected (unbuffered)
- USB 2.0 port type B
- SIM card tray
- 40 pin header connected to the board to board connector of the NAD6200 – module.
- 3 GSBI ports connected to DB9 or pin header.
Figure 10: Evaluation Kit for NAD6200 module
Using the evaluation board with on board 3.8 V regulator:
- Connect between 11 and 14 V DC to power connector 1) by using delivered cable
- Power up on the board with switch 2)
Using the evaluation board with an external power supply:
- Remove Jumper 3)
- Switch 2) to off condition
- Connect external supply between 3.6 and 4.0 V DC to connector 4)
- Connector 4) Pin out: Pin 1: GND
Pin 2: Sense GND
Pin 3: Sense V+
Pin 4: V+
Note: Make sure that the external power supply is not generating spikes or hazards higher
than 4.2 V. NAD6200 module gets damaged when spikes or hazards are above 4.2 V.
RF Connector: