User's Manual

Federal Communications Commission

Authorization and Evaluation Division

Equipment Authorization Branch

7435 Oakland Mills Road, Columbia, MD 21046,

U.S.A.

Subject: FCC Compliance Statements Date: January 10, 2007

FCC ID: QWY-CKII-RAZR

Gentlemen:

PEIKER acustic hereby confirms that the attached FCC Compliance Statements (§15.21

and §15.105 Information to the User) will be readily visible to the user, and will be placed at

a prominent location in the front section of the user's manual.

Should you have any questions or comments concerning the above, please do not hesitate

to contact me.

Sincerely Yours,

Wolfgang Förderer Andreas Frpfcil

Department Manager TechnicalTroject Manager

PEIKER acustic GmbH & Co. KG

PEIKER acustic GmbH & Co. KG • Max-Planck-Strasse 32 • D-6138] Friedrichsdorf/Ts. • Amtsgericht Bad Homburg HRA 1897

phG: PEIKER Verwaltungs GmbH

Vorsitzender der Geschäftsführung: Andreas Peiker • Geschäftsführer: Stephan Graf von der Schulenburg

Amtsgericht Bad Homburg HRB 1369

Ein Unternehmen der PEIKER Firmengruppe

PAGE 1
Federal Communications Commission Authorization and Evaluation Division Equipment Authorization Branch 7435 Oakland Mills Road, Columbia, MD 21046, U.S.A. Subject: FCC Compliance Statements Date: January 10, 2007 FCC ID: QWY-CKII-RAZR Gentlemen: PEIKER acustic hereby confirms that the attached FCC Compliance Statements (§15.21 and §15.105 Information to the User) will be readily visible to the user, and will be placed at a prominent location in the front section of the user's manual.
PAGE 2
RF Exposure statement: The antenna shown in this filing must not be co-located or operated in conjunction with any other antenna or transmitter. integrators need no SAR evaluation. The max source-based time-averaged output of 0.0005 W is below the low threshold of 24mW for d < 1.5 cm. Statement according to FCC part 15.21: Modifications not expressly approved by this company could void the user's authority to operate the equipment. Statement according to FCC part 15.
PAGE 3
- Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver isconnected. - Consult the dealer or an experienced radio/TV technician for help.