User's Manual

PARTIAL SECTION 7
To complete the pairing process, you will need to reference
yourcellular phoneowner’smanual. The UConnect™ web-
site may also provide detailed instructions for pairing.
The following are general phone to UConnect™ System
pairing instructions:
•
Press the “Phone” button to begin.
•
After the "Ready" prompt and the following beep, say
"Setup Phone Pairing."
•
When prompted, after the beep, say "Pair a Phone" and
follow the audible prompts.
•
You will be asked to say a four-digit pin number, which
you will later need to enter into your cellular. You can
enter any four-digit pin number. You will not need
to remember this pin number after the initial pairing
process.
•
For identification purposes, you will be prompted to
give the UConnect™ system a name for your cellular
phone. Each cellular phone that is paired should be
given a unique phone name.
•
You will then be asked to give your cellular phone
a priority level between 1 and 7, 1 being the highest
priority. You can pair up to seven cellular phones
to your UConnect™ system. However, at any given
time, only one cellular phone can be in use, connected
to your UConnect™ System. The priority allows the
UConnect™ system to know which cellular phone to use
if multiple cellular phones are in the vehicle at the same
time. For example, if priority 3 and priority 5 phones are
present in the vehicle, the UConnect™ system will use
the priority 3 cellular phone when you make a call. You
can select to use a lower priority cellular phone at any
time (refer to "Advanced Phone Connectivity").
Dial by Saying a Number
•
Press the “Phone” button to begin.
•
After the "Ready" prompt and the following beep, say
"Dial."
•
System will prompt you to say the number you want call.