User's Manual

20 PARTIAL SECTION
Things You Should Know About Your UConnect™
System
UConnect™ Tutorial
To hear a brief tutorial of the system features, press the
“Phone” button and say “UConnect™ Tutorial.”
Voice Training
For users experiencing difficulty with the system recogniz-
ing their voice commands or numbers, the UConnect™ sys-
tem Voice Training feature may be used. To enter this train-
ing mode, follow one of the two procedures:
From outside the UConnect™ mode (e.g. from radio mode)
•
Press and hold the “Voice Recognition” button for 5
seconds until the session begins, or,
•
Press the “Voice Recognition” button and say "Setup,
Voice Training" command.
Repeat the words and phrases when prompted by the
UConnect™ system. For best results, the Voice Training
session should be completed when the vehicle is parked,
engine running, all windows closed, and the blower fan
switched off.
This procedure may be repeated with a new user. The sys-
tem will adapt to the last trained voice only.
To restore the Voice Recognition system to factory default
settings, enter the Voice Training session via the above pro-
cedure and follow the prompts.
Voice Recognition (VR)
•
For best performance adjust the rear view mirror to
provide at least
inch (1 cm) gap between the overhead
console (if equipped) and the mirror.
•
Always wait for the beep before speaking.
•
Speak normally, without pausing, just as you would
speak to a person sitting approximately eight (8) feet
away from you.
•
Make sure that no one other than you is speaking during
a voice recognition period.