User Manual

page 5
The copyright protection of this original document remains with Peiker acustic GmbH & Co. KG. Without prior written authorization it shall not be copied or otherwise
reproduced by a third party and shall not be disclosed to competitors. The infringement shall be strictly enforced by applicable civil and criminal legal proceedings.
3 Antenna installation
To comply with the RF exposure requirements of the FCC following requirements have to be fulfilled:
The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20
cm from all persons. This device is to be used in mobile or fixed applications only.
Following technologies and frequency bands are supported by the device ATM-01 T2-US-4GW:
Radio Access
Technology
Supported Frequency Bands
GSM/GPRS/EDGE GDM850, GSM1900
WCDMA FDD2, FDD5
LTE eFDD2, eFDD4, eFDD5, eFDD17
For mobile and fixed operating configurations the antenna gain, including cable loss, must not exceed
-1.15 dBd
at 700MHz & 850MHz
1 dBi
at 1700MHz & 1900MHz
for satisfying RF exposure compliance.
It must be ensured by the OEM that the end user has no manual instructions to remove or install the RF
unit of the device.