Operating instructions

GB - 220-FU-BLS (Rev03_080902)
Paul Hochköpper GmbH & Co. KG
Postfach 1727 • D-58467 Lüdenscheid • Tel.: [phone] • Fax: [phone] • e-mail: [e-mail] • Internet: www.peha.de
5.1 Note on installation
• Donotuseintheopen(onlywithinclosedrooms).
• Beforetheinstallationonroughsurfaces,asmoothsurfacehastobecreated.
Unevenness may lead to transmitter’s malfunctions.
• Wheninstalling,mindtherequiredpositionofinstallationshownonthebackof
the transmitter (O = top , I = bottom) (1).
• DoNEVERinstallthetransmitterwithinametalbodyorintheimmediatevicinity
of big metal objects. An installation near or on the ground is not recommendable.
5.2 Mounting
a) Screws:
 • Retainingplates(4) shall be used as a template to mark the drill holes.
 • Drilldowelholesof5mm.
 • Fix the retaining plate with included screws. The latches of the retainin plate
have to be positioned for their installation as shown under point 4.
 • Engagewalltransmitter(2) and frame (3) on the retaining plate.
b) Gluing:
  •Engagewalltransmitter(2) and frame (3) on the retaining plate (4).
 • Useadhesive strips for the installation on flat, smooth surfaces (such as
painted walls, tiles, furniture, wood, etc.) Glue the adhesive strip to both
the upper and lower recess on the indentation of the retaining plate.
 • Use adhesive film for the installation on glass. Glue the adhesive film to the
inverse side of the retaining plate.
 • Glue the assembled wall transmitter to the desired place.
5.3 Commissioning
• Installationofthereceiver(onlybyanelectrician).
•Assignwalltransmittertoreceiver.
6.1 New system or existing system
• Checktheimmediatesurroundingsofthesystemsforchangesthatmightcause
malfunctions (for example, previously moved metal cabinets, furniture or walls).
• Iftransmitter/receiverworkatacloserdistance,thereeithermightbeinterference
or the system was used outside the transmission range.
• Placementofthetransmitteratamoreconvenientlocation.
6.2 Radio signal range limitations
•Useofthetransmitter/receiverinthevicinityofmetalobjectsormaterialswith
metal components. Maintain a distance of at least 10 cm.
•Moistmaterials.
•Deviceswhichemithigh-frequencysignals(e.g.audioandvideosystems,compu-
ters, electronic ballasts in lightfixtures). Maintain a distance of at least 0.5 m.
6.3 Contact
Telephone:................ [phone]
Fax:.......................... [phone]
Internet:.................... www.peha.de/contact.aspx
E-mail:...................... [e-mail]
PEHA products may be sold and operated in EU countries as well as in CH, IS
and N. PEHA herewith declares that the Easyclick wall transmitter is in compli-
ance with the fundamental requirements and other relevant provisions of R&TTE
Directive 1999/5/EC. The conformity declaration is available on the Internet at the
following address: www.peha.de/ServiceDownloads.aspx.
1 2 3 4
5. Mounting and commissioning
6. Troubleshooting & remedies
7. Conformity declaration