User's Manual
Table Of Contents
- Before You Begin
- Cisco WAP571E Wireless-AC/N Premium Dual Radio Outdoor Access Point Features
- Mounting the Cisco WAP571E Wireless- AC/N Premium Dual Radio Outdoor Access Point
- Connecting the Cisco WAP571E Wireless- AC/N Premium Dual Radio Outdoor Access Point
- Verifying the Hardware Installation
- Getting Started with the Configuration
- Suggested Next Steps
- Rebooting the Devices or Returning them to their Factory Default Settings
- Where to Go From Here
Cisco WAP571E Wireless Access Point 4
WARNING Insecure mounting might damage the device or cause injury.
Cisco is not responsible for damages incurred by insecure wall
or pole mounting.
Pole-mounting: To mount the Cisco WAP 571E device on a pole:
STEP 1 Fix Holder_1 and GND wire on WAP571E by 4 M6*10 screws and
screw washers. GND wire can provide better ESD protection.
STEP 2 Fix Holder_2 and Holder_3 on Pole by 4 M6*130 screws and screw
washers.
STEP 3 Fix WAP571E and Holder_1 to Holder_2 by 4 M6*10 Screws and
screw washers.