User's Manual
Table Of Contents
- Before You Begin
- Cisco WAP571E Wireless-AC/N Premium Dual Radio Outdoor Access Point Features
- Mounting the Cisco WAP571E Wireless- AC/N Premium Dual Radio Outdoor Access Point
- Connecting the Cisco WAP571E Wireless- AC/N Premium Dual Radio Outdoor Access Point
- Verifying the Hardware Installation
- Getting Started with the Configuration
- Suggested Next Steps
- Rebooting the Devices or Returning them to their Factory Default Settings
- Where to Go From Here
28
Regulatory Compliance and Safety Information for the Cisco WAP571/571E Wireless Access Point (EMC Class B Devices)
78-20515-02
Japanese Electric Appliance and Radio Laws
Japanese Electric Appliance and Radio Laws
Statement 571/571E—Power Cable and AC Adapter
Radio
This section describes radio compliance conditions for the Cisco WAP571/571E Wireless Access Points
EMC Class B Devices.
Caution The Part 15 radio device operates on a non-interference basis with other devices operating at this
frequency when using the integrated antennas. Any changes or modification to the product not expressly
approved by Cisco could void the user’s authority to operate this device.
Canadian Radio Warning Statement
This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Ce dispositif est conforme aÌ la norme CNR-210 d'Industrie Canada applicable aux appareils radio exempts
de licence. Son fonctionnement est sujet aux deux conditions suivantes: (1) le dispositif ne doit pas produire
de brouillage preìjudiciable, et (2) ce dispositif doit accepter tout brouillage rec?u, y compris un brouillage
susceptible de provoquer un fonctionnement indeìsirable.
Warning
When installing the product, please use the provided or designated connection cables/power
cables/AC adaptors/batteries. Using any other cables/adaptors could cause a malfunction or a
fire. Electrical Appliance and Material Safety Law prohibits the use of UL-certified cables (that
have the “UL” or “CSA” shown on the cord), not regulated with the subject law by showing
"PSE" on the cord, for any other electrical devices than products designated by CISCO.
RSS-247
CNR-247