User's Manual

USERS MANUAL OF THE END PRODUCT:
In the users manual of the end product, the end user has to be informed to keep at least 20cm
separation with the antenna while this end product is installed and operated. The end user has to
be informed that the IC radio-frequency exposure guidelines for an uncontrolled environment can
be satisfied. The end user has to also be informed that any changes or modifications not
expressly approved by the manufacturer could void the user's authority to operate this equipment.
IC statement is required to be available in the users manual: This Class B digital apparatus
complies with Canadian ICES-003. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference and (2) this device must accept any interference
received, including interference that may cause undesired operation.
LABEL OF THE END PRODUCT:
The final end product must be labeled in a visible area with the following " Contains TX IC : 7582A
- UPWL6017SH2 ".
6. Antenna information
This radio transmitter(IC: 7582A-UPWL6017SH2) has been approved by Industry Canada to operate with
the antenna types listed below with the maximum permissible gain and required antenna impedance for
each antenna type indicated. Antenna types not included in this list, having a gain greater than the
maximum gain indicated for that type, are strictly prohibited for use with this device.
Cet émetteur radio (IC: 7582A-UPWL6017SH2) a été approuvé par Industrie Canada pour fonctionner
avec les types d'antennes énumérés ci-dessous avec le gain maximal admissible et nécessaire
impédance d'antenne pour chaque type d'antenne indiqué. Types d'antennes ne figurent pas dans cette
liste, ayant un gain supérieur au gain maximum indiqué pour ce type, sont strictement interdites pour une
utilisation avec cet appareil.
"To reduce potential radio interference to other users, the antenna type and its gain should be so chosen
that the equivalent is otropically radiated power (EIRP) is not more than that required for successful
communication"
"This device has been designed to operate with an antenna having a maximum gain of 2.7 dBi. Antenna
having a higher gain is strictly prohibited per regulations of Industry Canada. The required antenna
impedance is 50 ohms."
«Pour réduire le risque d'interférence avec d'autres utilisateurs, le type d'antenne et son gain doivent être
choisis afin que la puissance isotrope rayonnée équivalente (PIRE) ne dépasse pas ce qui est nécessaire
pour une communication réussie"
«Ce dispositif a été conçu pour fonctionner avec une antenne ayant un gain maximal de 2.7 dBi. Antenne
ayant un gain supérieur sont strictement interdites par la réglementation d'Industrie Canada. L'impédance
d'antenne requise est de 50 ohms."
This module card will be sold with two sets of antenna as following table.
 HL Technology
Antenna Model Type
Connector
2400~2483.5MHz
260-26028 PCB
UFL
2.58 dBi
260-26013 PCB
UFL
2.7 dBi