Manual Unihan UPWL6017SH2
1.General Description The UPWL6017SH2 wireless module is a fully assembled and tested general-purpose module using the BCM43217KMLG wireless System-on-Chip(SoC). The module contains BCM43217KMLG chip and all other necessary components to operate the UPWL6017SH2. For detailed information on the UPWL6017SH2 component itself, refer to the UPWL6017SH2 datasheet. 2. Features Features Description Network Standard IEEE 802.11 b/g/n (final n) Chipset BCM43217KMLG Input Voltage 3.3V,5V Data Rate 802.
. Benefits Small, self-contained SMT module. 2X2 MIMO function support High power solution support high speed transmittance For product available in the USA/Canada market, only channel 1~11 can be operated. Selection of other channels is not possible. 4. FCC Statement Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
IMPORTANT NOTE: This module is intended for OEM integrator. The OEM integrator is responsible for the compliance to all the rules that apply to the product into which this certified RF module is integrated. Additional testing and certification may be necessary when multiple modules are used. 20cm minimum distance has to be able to be maintained between the antenna and the users for the host this module is integrated into.
must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
USERS MANUAL OF THE END PRODUCT: In the users manual of the end product, the end user has to be informed to keep at least 20cm separation with the antenna while this end product is installed and operated. The end user has to be informed that the IC radio-frequency exposure guidelines for an uncontrolled environment can be satisfied. The end user has to also be informed that any changes or modifications not expressly approved by the manufacturer could void the user's authority to operate this equipment.
. About this guide This user guide contains the information your PEGATRON WIFI Module. 8. System requirements Before installing the PEGATRON WIFI module, make sure that your system meets the following requirements: Intel® Pentium® 4 or AMD K7/K8 system Minimum 64MB system memory Windows® XP/VISTA operating system 9. Installing the device drivers To install the device driver in your computer: Insert the support CD to the optical drive and follow the following procedure.
Step 2 Step 3
Step 4 Step 5
