User's Manual

9
DeutschEnglishFrançaisNederlandsItalianoEspañolPortuguês
Care and cleaning instructions
Never spray liquids onto the telephone since any liquid penetrating the telephone
can lead to malfunctions or destruction of the device.
Any substances such as alcohol, chemicals, solvents or scouring agents should also
be avoided since these may damage the surface.
Clean the telephone with a soft cloth moistened with water.
Documentation on Internet
This and other documentation can be found on the Internet at:
http://www.unify.com Support.Technical notes, current infor-
mation about firmware updates, frequently asked questions and
lots more can be found on the web at:
http://wiki.unify.com
Package Content
a OpenScape Desk Phone CP600
b Stand
c Handset
d Handset cable
e Installation and Quick Reference Guide
Notes about Place of Use
Operation of a SIP telephone is only permitted with indoor LAN cabling.
The device shall be connected to the IP infrastructure using a shielded
LAN cable: Cat-5 for 100 Mb/s or Cat-6 for 1000 Mb/s. The LAN cabling
of the building shall ensure that the shield of this cable is grounded.
The telephone should be operated in a controlled environment with an
ambient temperature between 5 °C and 40 °C (41 °F and 104 °F).
Do not install the telephone in a room where large quantities of dust ac-
cumulate; this can considerably reduce the service life of the telephone.
Do not expose the telephone to direct sunlight or any other source of
heat, as this is liable to damage the electronic equipment and the plastic
casing.
Do not operate the telephone in damp environments such as bath-
rooms.
Connect the Handset to the Telephone
See also overview on page 2.
1. Insert the plug on the long end of the handset cable d into the
jack on the base of the telephone and press the cable into
the groove provided.
2. Insert the plug on the short end of the handset cable d into the
jack on the handset
c.
a
b
e
c
d
F
KBA.book Seite 9 Dienstag, 14. Juni 2016 11:01 11