User's Manual
Table Of Contents
- Notice à l’attention des installateurs de réseaux câblés
- Mitteilung für CATV-Techniker
- Aviso a los instaladores de sistemas CATV
- IMPORTANT SAFETY INSTRUCTIONS
- Power Source Warning
- Ground the Product
- Protect the Product from Lightning
- Verify the Power Source from the On/Off Power Light
- Eliminate AC Power/Mains Overloads
- Provide Ventilation and Select a Location
- Operating Environment
- Protect from Exposure to Moisture and Foreign Objects
- Service Warnings
- Check Product Safety
- Protect the Product When Moving It
- United States FCC Compliance
- Introducing the DOCSIS Wireless Residential Gateway
- Purpose
- Installing the DOCSIS Wireless Residential Gateway
- Introduction
- Operation of Front Panel Indicators
- Introduction
- Troubleshooting the DOCSIS Wireless Residential Gateway
- Frequently Asked Questions
- How Do I Configure TCP/IP Protocol?
- How Do I Renew the IP Address on My PC?
- What if I Don't Subscribe to Cable TV?
- How Do I Arrange for Installation?
- How Does the Wireless Residential Gateway Connect to My Computer?
- After My Wireless Residential Gateway Is Connected, How Do I Access the Internet?
- Can I Watch TV and Surf the Internet at the Same Time?
- Common Troubleshooting Issues
- Tips for Improved Performance
- Frequently Asked Questions
- Introduction
- Customer Information
- Introduction
- Index
United States FCC Compliance
OL-30 545 -01 xiii
National Restrictions
This product is for indoor use only.
USA/Canada
This system has been evaluated for RS-210. When operating this system, adhere to the
following requirements:
When operating in the band 5150-5250 MHz, the device is only for indoor use to reduce
the potential for harmful interference to co-channel mobile satellite systems.
The maximum antenna gain permitted for devices in the bands 5250-5350 MHz and 5470-
5725 MHz shall comply with the EIRP limit.
The maximum antenna gain permitted for devices in the band 5725-5825 MHz shall
comply with the EIRP limits specified for point-to-point and non point-to-point
operation as appropriate.
Users should also be advised that high-power radars are allocated as primary users (i.e.
priority users) of the bands 5250-5350 MHz and 5650-5850 MHz and that these radars
could cause interference and/or damage to LE-LAN devices.
Operation in the 5600- 5650 MHz band in the US is not permitted at this time to avoid
interference with Terminal Doppler Weather Radar systems operated by the FAA. This
requirement is applicable to systems installed indoors or outdoors. Note: Industry
Canada also restricts operation of this band per RSS-210. Systems being installed
outdoors are subject to the following restrictions:
a Systems must be professionally installed by trained qualified engineer or technicians.
b Systems must be installed per the recommended guidelines in the installation guide
for the outdoor systems.
c The use of non-approved Cisco antennas or unauthorized modifications could affect
the operation of the system and result in interference to the TDWR and as such the
operator could be held liable for such interference.