User's Manual

Check Product Safety
Upon completion of any service or repairs
to this product, the service technician must
perform safety checks to determine that this
product is in proper operating condition.
Protect the Product When
Moving It
Always disconnect the power source when
moving the apparatus or connecting or
disconnecting cables.
SAVE THESE INSTRUCTIONS
United States FCC Compliance
This device has been tested and found to
comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against such interference in a
residential installation. This equipment generates,
uses, and can radiate radio frequency energy.
If not installed and used in accordance with the
instructions, it may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined by
turning the equipment OFF and ON, the user is
encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the
equipment and receiver.
Connect the equipment into an outlet on a
circuit di erent from that to which the receiver
is connected.
Consult the service provider or an experienced
radio/television technician for help.
Any changes or modi cations not expressly
approved by Cisco Systems, Inc., could void
the user’s authority to operate the equipment.
The information shown in the FCC Declaration
of Conformity paragraph below is a
requirement of the FCC and is intended to
supply you with information regarding the FCC
approval of this device. The phone numbers
listed are for FCC-related questions only
and not intended for questions regarding the
connection or operation for this device. Please
contact your service provider for any questions
you may have regarding the operation or
installation of this device.
Declaration of Conformity
This device complies with Part 15 of FCC
Rules. Operation is subject to the following
two conditions: 1) the device may not cause
harmful interference, and 2) the device must
accept any interference received, including
interference that may cause undesired
operation.