Installation Guide

3

• 
• 
• 

• -


” 

• 
2

 1 
 1
 2
 16’ & 8’ 
 4’, 15 6’, 8’) 
 5 
 8-
V3.P.A.T-00000106
39” 45”
 Pencil
 Tape measure
 Level
 Cordless drill or
impact
 Miter saw
 Right angle driver
 #1 Square bit
 #2 Square bit
 #2 Phillips bit
 Clamps
 Speed square
 String line
1

Manufacturer Recommends:
 Impact Ready Right Angle
Aachment
LEVEL RAILING INSTRUCTIONS
STOP!
CHECK ALL LOCAL BUILDING CODES BEFORE YOU BEGIN!
Manufacturer Tip:
Use Power lags to avoid having
to pre-drill holes for a faster and
smoother install
(a)
(b
(c)
(c)
(d
(e)
QUESTIONS OR CONCERNS?
CALL IN-PERSON M-F 8:00AM TO 5:00 PM [phone]
CONTACT US 24/7 AT WWW.PEGATHA.NET