Installation Guide

7
Installing the diverter valve
body
□ From underneath the deck, insert the diverter
valve body (R) with the rubber washer (S),
metal washer (T) and mounting nut (U) through
the hole.
□ From above, thread the ange (Q) onto the
diverter valve body (R).
□ Tighten the mounting nut (U) using a basin
wrench, so that the ange (Q) sits ush against
the nished deck surface.
6
Removing the mounting kits
□ Remove the index (N). Loosen the set screw (O)
with the Hex wrench (Hex: 2.5mm, AA) and
remove the diverter handle (P).
□ Loosen the ange (Q) from the diverter valve
body (R). Adjust the rubber washer (S), metal
washer (T) and mounting nut (U) to the bottom
of diverter valve body (R).
6
Installation (continued)
NOTE: Make sure that the face marked with "FRONT" on
the diverter valve body (R) is facing forward.
R
S
T
U
Q
N
O
P
AA
Q
R
S
T
U