Installation Guide
5
Installation (continued)
4
Installing the valve bodies
□ From underneath the deck, insert the cold end
valve (J) with the rubber washer (K), metal
washer (L) and mounting nut (M) through
the hole on the right (cold) side.
□ From above, thread the ange (H) onto the
valve body (J).
□ Tighten the mounting nut (M) using a basin
wrench, so that the ange (H) sits ush against
the nished deck surface.
□ Repeat this procedure for the hot end valve (I)
on the left (hot) side.
NOTE: The hot end valve is identied with a label.
5
Installing the handle
□ Place the handle (G) onto the inverter (1). Place
the set screw (F) into handle (G) and tighten set
screw (F) with the Hex wrench (Hex: 2.5mm, AA).
Insert the index (E).
□ Place the other handle onto the left (hot) valve
and install the same way.
H
K
L
M
J
I
G
F
E
AA
1
WWW.HOMEDEPOT.COM/PEGASUS
Please contact 1-877-580-5682 for further assistance.