Installation Guide

Installation

Preparing for installation

CAUTION: Always turn off the water supply before

removing an existing faucet or replacing any part of a

faucet. Open the faucet handle to relieve water pressure

and ensure that the water is completely shut off.

□ Shut off the water supply. Remove the old

faucet.

□ Clean the mounting surface.

□ Drill holes in the nished deck as shown in

the diagram below.

5 in. min.

8~16 in.

4~6 in.

3 in. min.

1-3/4 in. MAX. DECK THICKNESS

1-1/8 in.

Diamter

1-3/8 in.

Diamter

1-3/8 in.

Diamter

1-3/8 in.

Diamter

1-3/8 in.

Diamter

NOTE: This kit allows up to 1-3/4 in. deck thickness.

Installing the spout assembly

□ Remove the preassembled mounting nut (D) and

washers (B & C) from the spout assembly (A).

□ Insert the spout assembly (A) through the hole

in the deck.

□ Before installation, ensure that the ange (EE) is

placed on the bottom of the spout assembly (A).

□ Secure the spout assembly (A) with the rubber

washer (B), metal washer (C) and mounting

nut (D).

Removing the mounting kits

□ Remove the indexes (E). Loosen the set screws

(F) with the Hex wrench (Hex: 2.5mm, AA) and

remove the handles (G).

□ Loosen the anges (H) from the valve bodys

(I & J). Adjust the rubber washers (K), metal

washers (L) and mounting nuts (M) to the

bottom of valve bodys (I & J).