Installation Guide

Place new faucet in position on sink. From under sink,
thread nuts onto faucet. Tighten nuts.
(A) Stainless Steel Braided Faucet Supply Tubes: This is
the simplest of all installations. If you are using stainless
steel braided faucet supply tubes, this faucet requires one
end of the supply tube to have a 1/2" female IPS
connection. The other end of this supply tube must match
the thread on the water supply fittings or shut off valve
under your sink. Once you have identified the required
tube, carefully follow the manufacturer’s installations
instructions for each tube.
Shut off water supply. Remove old faucet. Clean sink
surface in preparation for new faucet.
Preparation/Assembly
1
1
2
3A
2
3A
Steps 1-3A