Installation Guide
4
Installation
1
Installing the faucet assembly
CAUTION: Always turn off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□ Place the faucet (A) through the mounting
holes in the sink.
□ Ensure the slot openings of the washers (G) face
toward to the rear of the sink.
2
Installing the faucet handles
□ Remove the preassembled nuts (E) and washers
(D) from the hot and cold faucet handles (B and C).
□ Insert the hot faucet handle (B) to the left of the
spout and cold faucet handle (C) to the right of
the spout.
NOTE: The hot water valve is identied with a label.
□ Shut off the water supply. Remove the old
faucet.
□ Clean the mounting surface.
□ Loosen the screws (F) on the nuts (E) until the
ends of the screws (F) are ush with the face of
the nuts (E).
□ Attach the faucet handles (B and C) underneath
the sink using the washers (D) and nuts (E).
Securely tighten the screws (F) on the nuts (E).
□ Secure the faucet (A) to the sink using the lock
nut (H) provided.
1
1
F
E
□ Remove the preassembled lock nut (H) and
washers (G) from the new faucet (A).
A
1
H
G
H
2
A
3
2
2
B
C
E
D
F
E
D
F
3
3
F
4
E
5