Installation Guide

6
Installation (continued)
3
Preparing the pop-up drain
□ Remove the old pop-up drain and clear up the
hole in preparation for the new pop-up drain
installation.
□ Unscrew the nut (K) from the pop-up body (F),
move over the tail pipe (L) and washer (J), then
unscrew the coupling nut (I) and remove the
washer (H).
4
Installing the pop-up body
□ Place the washer (G) underneath the ange of
the pop-up body (F). Slide the pop-up body (F)
down through the drain hole on the vessel or
basin.
□ From underside, slide the washer (H) against
the bottom of the vessel or basin, thread on
the coupling nut (I) and tighten. Do not over
tighten.
5
Installing the tail pipe
□ Slide the nut (K) over the tail pipe (L).
□ Place the washer (J) into the nut and
tighten. Do not overtighten.
F
H
K
L
I
J
F
H
I
G
K
L
J