Instruction Manual

✓ Modulus luminaires should only receive low voltage DC power provided from an adequately-
rated Modulus head unit. DO NOT CONNECT LINE VOLTAGE TO MODULUS
LUMINAIRES.
✓ Never connect components under load.
✓ Do not mount or support these fixtures in a manner that can cut the outer jacket or damage
wire insulation.
✓ Unless individual product specifications deem otherwise: Never connect an LED product
directly to a dimmer packs, occupancy sensors, timing devices, or other related control
devices. LED fixtures must be powered directly off a switched circuit.
✓ Unless individual product specifications deem otherwise: Do not restrict fixture ventilation.
Allow for some volume of airspace around fixture. Avoid covering LED fixtures with
insulation, foam, or other material that will prevent convection or conduction cooling.
✓ Unless individual product specifications deem otherwise: Do not exceed fixtures maximum
ambient temperature.
✓ Only use fixture in its intended location.
✓ LED products are Polarity Sensitive. Ensure proper Polarity before installation.
✓ Electrostatic Discharge (ESD): ESD can damage LED fixtures. Personal grounding equipment
must be worn during all installation or servicing of the unit.
✓ Do not touch individual electrical components as this can cause ESD, shorten lamp life, or
alter performance.
✓ Some components inside the fixture may not be serviceable. In the unlikely event your unit
may require service, stop using the unit immediately and contact an ABL representative for
assistance.
✓ Always read the fixtures complete installation instructions prior to installation for any
additional fixture specific warnings.
CAUTION
RISK OF PRODUCT DAMAGE
Please see product specific installation instructions for additional warnings or any applicable FCC or other regulatory
statements.
Failure to follow any of these instructions could void product warranties. For a complete listing of product Terms and
Conditions, please visit www.acuitybrands.com.
Acuity Brands Lighting, Inc. assumes no responsibility for claims arising out of improper or careless
installation or handling of its products.
ABL LED General Warnings, Form No. 503.203
© 2010 Acuity Brands Lighting, Inc. All rights reserved. 12/01/10
SAVE THESE INSTRUCTIONS AND DELIVER TO OWNER
AFTER INSTALLATION
© 2014 Acuity Brands Lighting, Inc. All Rights Reserved.. Products in this document may be covered by one or more U.S. Patents and Patents Pending. Specifications subject to change without
notice. Limited warranty applies. Complete warranty terms located at www.AcuityBrands.com/CustomerResources/Terms_and_Conditions.aspx
IMPORTANT SAFETY INSTRUCTIONS
Modulus
PEERLESS RENNA
2