manual

ISSUED: 1-17-2014 SHEET #: 120-9189-1 1-17-2014

1 of 3

Visit the Peerless Web Site at www.peerless-av.com For customer care call 1-800-865-2112

Installation and Assembly - Double Stack Box Accessory

Model: PLCM-4

IMPORTANT! Read entire instruction sheet before you start installation and assembly.

Parts List

Part #Description Qty

A mounting box 1 124-1841

B tilt bracket 1 200-1552

C M10 x 15mm penta-pin screw 8 520-9263

D penta-pin driver 1 520-9260

E u-bolt 2 560-1060

F nylock nut 4 530-9310

G at washer 4 540-9454

NOTE: SOME PARTS MAY APPEAR SLIGHTLY DIFFERENT THAN ILLUSTRATED

PAGE 1
Installation and Assembly - Double Stack Box Accessory Model: PLCM-4 IMPORTANT! Read entire instruction sheet before you start installation and assembly. Parts List A B C D E F G Description mounting box tilt bracket M10 x 15mm penta-pin screw penta-pin driver u-bolt nylock nut flat washer Qty 1 1 8 1 2 4 4 Part # 124-1841 200-1552 520-9263 520-9260 560-1060 530-9310 540-9454 NOTE: SOME PARTS MAY APPEAR SLIGHTLY DIFFERENT THAN ILLUSTRATED A C E B D Visit the Peerless Web Site at www.
PAGE 2
WARNING • Installer must verify that the ceiling will safely support the combined weight of all attached equipment and hardware. 1 Securely fasten mounting box (A) to support pipe (not included) using two u-bolts (E), four flat washers (G) and four nylock nuts (F). F G E A SUPPORT PIPE (NOT INCLUDED) fig 1.1 1-1 BY HAND, insert four M10 x 1.5 x 15 mm penta-pin screws (C) into threaded holes in the sides of ceiling arm box (A). Leave approximately 1/4" of exposed thread as shown in detail 1.
PAGE 3
Installation of Plasma Screens and 30" or Larger LCD Screens NOTE: Refer to adapter plate instruction sheet for attachment of adapter plate to plasma before proceeding with step 2. Attach tilt bracket (B) to adapter plate using four M10 x 15 mm penta-pin screws (C) in accordance with appropriate drawing below. Tighten using M10 penta-pin tool (D).