Datasheet

10
date:01/22/13 #:125-9401
Rotate toggler (I) clockwise to wedge it against
inside walls.
Push into hole.
Pivot end of toggler (I).
Slide plastic cap forward while pulling back
rmly on ring.
Break off excess.
I
g. 1.3
drill
1/2"
hole
I
I
I
I
1
2
3
4
5
• Drywall must be 1/2" or thicker.
• Make sure that the wall will safely support the combined load of the equipment and all attached hardware and
components.
WARNING
1c-1
1c-2
Level cover plate and mark the center of the four mounting holes. Drill four 1/2" holes through drywall.
NOTE: It may be necessary to drill 5/32" pilot holes prior to drilling 1/2" holes.
D
2.5"
(64mm)
1/2"
(12mm)