manual

8 of 50
ISSUED: 07-12-10 SHEET #: 061-9056-8 03-05-13
NOTE: The installed display should allow a 1/2" air gap between the front of the display and the interior surface of
the window. A display mounted directly against the window will create a dead air space that traps heat which may
affect the funtionality of both the display and the enclosure mount.
Measure the depth of your display. Choose the appropriate fi xed stop-position from the chart below. Reinstall rear
supports with 3" serrated washer head screws and locknuts into appropriate fi xed stop-position as shown in fi gure
4.1. NOTE: Be sure "UP" arrow of rear support is pointing up as shown in fi gure 4.2.
Do not tighten fasteners.
• Failure to allow this space for air circulation and to allow heat to dissipate from the display may effect the visual ap-
pearance and/or cause damage to your display.
WARNING
Depth Adjustment
FIXED STOP-POSITION #1
FIXED STOP-POSITION #2
FIXED STOP-POSITION #3 FIXED STOP-POSITION #4
FIXED STOP-POSITION #5
4
Depth of Display
Fixed Stop-Position
1-1/8" - 2-1/8" (29 - 54 mm) #1
1-3/4" - 2-3/4" (44 - 70 mm) #2
2-3/8" - 3-3/8" (60 - 86 mm) #3
3" - 4" (76 - 102 mm) #4
3-5/8" - 4-5/8" (92 - 117 mm) #5
fi g. 4.1
fi g. 4.2
REAR SUPPORT
LOCKNUT
3" SCREW