IP Phone User Manual

3.3 PT Programming
Feature Guide 325
Entering System Programming Mode
System programming enables the extension user to set the time, call destination and all sorts
of system conditions within the limits of available programming. The administrator or manager
can also set up desired parameters for user programming. It is necessary to enter the relevant
password to start programming. Programming has two levels: Administrator Level and User
Level.
Administrator Level:
All system programming available for PT programming is accessible.
User Level:
Permitted system programming is accessible. Each access to system programming can be
controlled.
Note
means default value throughout this manual.
Programming Structure
Programming
Number
Programming Group Title Description
[0XX] Basic Programming Frequently used programming steps.
[1XX] System Programming Global system parameters.
[2XX] Time Programming Flexible system timers.
[3XX]
TRS/Barring/ARS
Programming
TRS/Barring and Automatic Route
Selection (ARS).
[4XX]
Trunk Programming Setting of trunk, trunk group, or BRI line
features.
[5XX] COS Programming Class of Service parameters.
[6XX] Extension Programming Assignment of the extension features
[7XX]
Resource/Interface
Programming
Assignment of the various interfaces on
the PBX.
[8XX]
SMDR & Maintenance
Programming
Setting of SMDR and maintenance
features.
[9XX]
Card Programming The programming used to refer to or delete
the card.
PROGRAM/
PAUSE
#
= 1234
System Password for Administrator
Programming No.
3 digits
—for PT Programming
= 1234
Programming No.
3 digits
System Password for User
—for PT Programming
PROGRAM/
PAUSE