Installation & Assembly

9 of 10

ISSUED: 10-12-05 SHEET #: 202-9038-5 05-04-07

Roll can be adjusted 1° clockwise or

counterclockwise.

To adjust roll, loosen screen fasteners slightly,

leaving them snug. Level screen, then tighten screen

fasteners.

Note: When adjusting roll, M6 screws should be tight

as indicated in step 10.

Screen can tilt 5° or 10° forward.

Note: Screen must be securely attached to mounting plate with all fasteners before adjusting tilt.

To tilt screen 5° forward, lift and pull mounting plate forward until middle notch rests on M6 screw as shown in figure

11.1. Tighten M6 screw.

To tilt screen 10° forward, lift and pull mounting plate forward until rear notch rests on M6 screw as shown in figure

11.2. Tighten M6 screw.

Note: For security models, tighten M6 screw using security allen wrench (M).

Optional: To lock one sliding arm of mount in place,

slide locking tab (B) over top or bottom of sliding arm

and attach to mount using one M5 x 10 mm screw

(AA) and one spacer (C).

Note: Screen not shown for clarity.

SLIDING ARM

fig. 11.1 fig. 11.2

5° tilt 10° tilt

M6 SCREW

MOUNTING

PLATE

M6 SCREW

MOUNTING

PLATE

SCREEN FASTENER