Installation & Assembly

8 of 10

ISSUED: 10-12-05 SHEET #: 202-9038-5 05-04-07

GENERIC

ADAPTER

BRACKET

FOR INSTALLING TO PEERLESS PLP MODEL ADAPTER BRACKET (not UL listed)

Note: Refer to PLP model adapter bracket instruction sheet for attachment of adapter bracket to screen.

Thread two M10 x 15 mm screws (K), leaving .25" exposed thread, into top holes on back of screen. Hook screen

onto mounting plate, and attach using two bottom M10 x 15 mm screws as shown in figures 7.7 and 7.8. Tighten

screws using 6 mm allen wrench (not included).

For screen compatibility please refer to the plasma interface list on our website www.peerlessmounts.com or

call customer care for a screen specific adapter bracket (PLP models).

GENERIC ADAPTER

BRACKET

MOUNTING PLATE

fig. 7.7

fig. 7.8

Slide one mesh sleeve (F) over each cable. Use

cable ties (G) to tighten both ends of mesh sleeves

to cables.

Note: If cable mounts (J) are used, loop cable ties

through cable mounts and tighten cable and mesh

sleeve to cable mounts.

MOUNTING PLATE

(NOTE: MOUNTING PLATE

SHOWN WITHOUT FULL

WALL MOUNT ASSEMBLY

FOR CLARITY)

Optional: To lock mount in closed position, insert

one M5 x 40 mm screw (DD) into tapped hole in

either top or bottom of flat plate.

Note: Screen not shown for clarity.

FLAT

PLATE

TAPPED HOLE