Installation & Assembly

ManualsBrandsPeerless-AV ManualsFurnitureTilt Wall Mount for Screens Holds up to 150 Lb. lbs

7 of 10

ISSUED: 10-12-05 SHEET #: 202-9038-5 05-04-07

• If screws don't get three complete turns in the screen inserts or if screws bottom out and adapter plate is still not

tightly secured, damage may occur to screen or product may fail. Contact customer care for correct hardware to use.

WARNING

Find the VESA

hole pattern as shown in figures 7.1 and 7.2, and attach screen to mounting plate as specified

below. Verify that all holes are properly aligned, and then tighten screws. If using security screws, tighten using

security allen wrench (M).

FOR INSTALLING TO VESA 100 MM, 200 MM HOLE PATTERN

VESA 100 VESA 200

fig. 7.1 fig. 7.2

FOR VESA 100 MOUNTING PATTERN:

Thread two M4 x 12 mm screws (BB), leaving .25" exposed thread, into top holes on back of screen. Hook screen

onto mounting plate, and attach using bottom two M4 x 12 mm screws as shown in figures 7.3 and 7.4. Tighten all

four screws.

Note: If screw (BB) is too small to engage threaded inserts, attach mounting plate to back of screen using four M5 x

10 mm screws (AA).

FOR VESA 200 MOUNTING PATTERN:

Thread two M4 x 12 mm screws (BB), leaving .25" exposed thread, into top holes on back of screen. Hook screen

onto mounting plate, and attach using two bottom M4 x 12 mm screws as shown in figures 7.3 and 7.4. Tighten all

four screws.

FOR SCREENS WITH VESA MOUNTING PATTERN IN A POCKET:

Thread two retaining spacers (L) onto two M4 x 20 mm screws (CC), leaving .25" exposed thread as shown in figure

7.5. Thread M4 x 20 mm screws with retaining spacers into top holes on back of screen. Hook screen onto mounting

plate, and attach using bottom two M4 x 20 mm screws and retaining spacers as shown in figures 7.3 and 7.4.

Tighten all four screws.

MOUNTING PLATE

(NOTE: MOUNTING PLATE

SHOWN WITHOUT FULL

WALL MOUNT ASSEMBLY

FOR CLARITY)

fig. 7.3

fig. 7.4

MOUNTING PLATE

(NOTE: MOUNTING PLATE

SHOWN WITHOUT FULL

WALL MOUNT ASSEMBLY

FOR CLARITY)

Note: Flat panel screen

may appear slightly

different than illustrated.

For screens with a hole

pattern in a pocket,

spacers (L) go between

mounting plate and

screen.

fig. 7.5