Installation & Assembly

6 of 10
ISSUED: 10-12-05 SHEET #: 202-9038-5 05-04-07
INSTALLATION TAB
A
SLIDING ARM
Place installation tab over sliding arms of wall mount
assembly (A) to lock them in place.
3
Optional: Using scissors, cut bumper strip (I) into
two 2" pieces and one 10" piece. Adhere bumper
strip pieces to wall mount assembly (A) where
indicated by reference marks.
4
I
I
I
REFERENCE
MARKS
Optional: Attach two cable mounts (J) to wall
mount assembly (A) using two M4 x 5 mm phillips
screws (H).
NOTE: Remove installation tab after arms are
locked.
6
A
H
J
Optional: Attach two spring clips (O) to wall mount
assembly (A) using four M3 x 4 mm phillips screws
(N).
NOTE: Remove installation tab after arms are
locked.
5
A
O
N