Installation User guide

ISSUED: 07-27-07 SHEET #: 124-9093-2 02-25-08

1 of 3

Visit the Peerless Web Site at www.peerlessmounts.com For customer care call 1-800-729-0307 or 708-865-8870.

Before you begin, make sure all parts shown are included with your product.

Parts List

Description Qty. Part#

mounting box 1 124-1841

tilt bracket 1 200-1552

M10 x 15 mm penta-pin screw 8 520-9263

penta-pin driver 1 520-9260

u-bolt 2 560-1060

nylock nut 4 530-9310

flat washer 4 540-9454

NOTE

: Some parts may appear slightly different than illustrated.

Installation and Assembly - Double Stack Box Accessory

Model: MIS-ACC201

IMPORTANT! Read entire instruction sheet before you start installation and assembly.

PAGE 1
Installation and Assembly - Double Stack Box Accessory Model: MIS-ACC201 IMPORTANT! Read entire instruction sheet before you start installation and assembly. Before you begin, mak e sure all parts shown are included with your product. A Parts List Description Qty.
PAGE 2
WARNING • Installer must verify that the ceiling will safely support the combined weight of all attached equipment and hardware. 1 Securely fasten mounting box (A) to support pipe (not included) using two u-bolts (E), four flat washers (G) and four nylock nuts (F). F E G A fig 1.1 SUPPORT PIPE (NOT INCLUDED) 1-1 BY HAND, insert four M10 x 1.5 x 15 mm penta-pin screws (C) into threaded holes in the sides of ceiling arm box (A). Leave approximately 1/4" of exposed thread as shown in detail 1.
PAGE 3
Installation of Plasma Screens and 30" or Larger LCD Screens NOTE: Refer to adapter plate instruction sheet for attachment of adapter plate to plasma before proceeding with step 2. 2 Attach tilt bracket (B) to adapter plate using four M10 x 15 mm penta-pin screws (C) in accordance with appropriate drawing below. Tighten using M10 penta-pin tool (D).