Installation Instruction Manual

6 of 7
ISSUED: 1-17-11 SHEET #: 125-9179-2 07-31-12
Using lock down plate (A) as a template mark the center of the four mounting holes. Drill four 1/2" holes through
drywall. NOTE: It may be necessary to drill 5/32" pilot holes prior to drilling 1/2" holes. Install togglers (I) as shown
A) to wall using four 1/4-20 x 1.5" screws (D) using 4 mm allen
wrench (H
1
 
 
components.
WARNING
Installation to Drywall
I) clockwise to wedge it against
inside walls.
Push into hole.
Pivot end of toggler (I).
Slide plastic cap forward while pulling back

Break off excess.
I
g. 1.3
drill
1/2"
hole
I
I
I
I

D
A
I
Figure. 1.4
1
2
3
4
5
Wii™