Installation Instruction Manual

4 of 7
ISSUED: 1-17-11 SHEET #: 125-9179-2 07-31-12


Installation to Solid Concrete or Cinder Block
 -
crete thickness in the hole to be used for the concrete anchors. Do not drill into mortar joints! Be sure to mount in a solid
-
tions. It is suggested that a standard electric drill on slow setting is used to drill the hole instead of a hammer drill to avoid
breaking out the back of the hole when entering a void or cavity.
 
 
components.
WARNING
1
Place lock down plate (A) on wall as a template. Level,
and mark the center of the two mounting holes.
Drill two 5/16" (8 mm) dia. holes to a minimum depth of
2.5" (64 mm). Insert anchors (E
as shown. Secure using two #14 x 2.5" wood screws (C)

Figure. 1.4
CUTAWAY VIEW
INCORRECT CORRECT
wall
plate
wall
plate
plaster/
dry wall
plaster/
dry wall
concrete
concrete
1
3
2
E
Drill holes and insert anchors (E).
Place lock down plate (A) over anchors (E) and secure with
screws (C).

A
E
C
concrete
surface
 
but do not overtighten. Overtightening can damage
screws, greatly reducing their holding power.
 
 directly
to load-bearing concrete.
 
concrete covered with plaster, drywall, or other



shown below. Be sure concrete anchors do not
pull away from concrete when tightening screws. If
plaster/drywall is thicker than 5/8" (16 mm), custom
fasteners must be supplied by installer.
WARNING
A
C
E
Wii™