Installation User guide

6 of 7
ISSUED: 1-17-11 SHEET #: 125-9181-1
Using lock down plate (A) as a template mark the center of the four mounting holes. Drill four 1/2" holes through
drywall. NOTE: It may be necessary to drill 5/32" pilot holes prior to drilling 1/2" holes. Install togglers (I) as shown
in gure 1.3. Loosely fasten lock down plate (A) to wall using four 1/4-20 x 1.5" screws (D) using 4 mm allen
wrench (H) as shown in gure 1.4. Level, hold, and then tighten all screws.
1
• Drywall must be 1/2" or thicker.
• Make sure that the wall will safely support the combined load of the equipment and all attached hardware and
components.
WARNING
Installation to Drywall
Rotate toggler (I) clockwise to wedge it against
inside walls.
Push into hole.
Pivot end of toggler (I).
Slide plastic cap forward while pulling back
rmly on ring.
Break off excess.
I
g. 1.3
drill
1/2"
hole
I
I
I
I
DRYWALL
D
A
I
Figure. 1.4
1
2
3
4
5
PlayStation
®
3